How do you reduce the water level on your 10000 gallon inground pool if it is about 2 inches above skimmer top?

1. Determine the Amount of Water to Drain:

- Measure the distance between the skimmer top and the water's surface. In this case, it is 2 inches.

- For each inch you need to lower the water, you will need to drain about 2,500 gallons (assuming a 10,000-gallon pool). To lower the water by 2 inches, you'll need to drain approximately 5,000 gallons (2 inches x 2,500 gallons per inch).

2. Set Up the Pool Filter and Pump:

- Connect a backwash or waste hose to the waste outlet port of the pool filter system. This will allow you to drain the water out of the pool.

3. Adjust the Filter Valve:

- Set the filter valve to "Waste" or "Drain." This diverts the water from circulating back into the pool and allows it to be discharged through the waste hose.

4. Monitor the Water Level:

- Keep an eye on the water level as the pool drains. Once it reaches the desired level, about 2 inches below the skimmer top in your case, turn off the pump.

5. Disconnect the Hose:

- Once the water level is lowered, turn off the pump, disconnect the waste hose, and reattach the cap or plug to the waste outlet port.

6. Adjust Chemical Levels:

- Lowering the water level may affect the chemical balance of the pool. Test the water and add the necessary chemicals, such as chlorine or pH balancers, to ensure proper water chemistry.

Remember to follow safety precautions when handling chemicals and draining the pool. If you have any concerns or require professional assistance, it's best to consult with a pool maintenance service.