Why would a swimming pool be losing water from the pump once filtration cycle finishes 4 times day if is only 1 year old and this problem has become apparent in last 2 weeks?

- Leak in the pump or filter system:

- Check for any visible cracks or damage on the pump housing, pipes, or filter tank.

- Tighten any loose connections or fittings.

- Replace any worn-out gaskets or seals.

- Defective check valve:

- The check valve prevents water from flowing back into the pool after the pump shuts off.

- A faulty check valve can cause water to leak out of the pump when it is not running, especially during the night when pump turns off.

-Inspect and clean or replace the check valve if necessary.

- Improper plumbing:

- Check for any kinks or bends in the pipes that could be restricting water flow.

- Ensure the pipes are properly connected and sealed.

- Damaged pool liner:

- If the pool liner has tears, holes, or punctures, water can leak out of the pool.

- Check for any damage and patch or replace the liner as needed.

- Overworked pump:

- If the pump is running for too long or too frequently, it can cause stress on the system and lead to leaks.

- Adjust the pump's run time and frequency to ensure it is not overworked, usually 8 to 12 hours per day in hot weather.

- Reduce filtration time to 3 times a day from the current 4 times a day for few weeks to see if leaks stops.

- High water pressure:

- High water pressure can put strain on the pool's plumbing and cause leaks.

- Check the water pressure and adjust it to the recommended level, typically around 15 to 25 PSI (pounds per square inch).

- Ground settlement or movement:

- If the ground around the pool has shifted or settled, it can cause the pipes to move and develop leaks.

- Check for any signs of ground movement and address the issue if necessary.

If you are unable to identify the source of the leak, it's best to consult with a professional pool technician for further assessment and repair.