When opening a pool what chemicals do you use and how get sand filter up running?

The following chemicals are typically used when opening a pool:

- Chlorine: Chlorine is a disinfectant that kills bacteria and other microorganisms in the pool water.

- pH balancer: pH balancers adjust the pH level of the pool water to keep it between 7.2 and 7.8.

- Alkalinity increaser: Alkalinity increasers raise the alkalinity level of the pool water to keep it between 80 and 120 ppm.

- Calcium hardness increaser: Calcium hardness increasers raise the calcium hardness level of the pool water to keep it between 200 and 400 ppm.

How to Get Sand Filter Up Running

To get a sand filter up and running, follow these steps:

1. Open the drain valve on the filter to let the water drain out.

2. Remove the top of the filter and scoop out the sand.

3. Rinse the sand filter with a garden hose to remove any dirt or debris.

4. Replace the sand in the filter and put the top back on.

5. Close the drain valve.

6. Turn on the pump and let the water circulate through the filter.

7. Check the pressure gauge on the filter and make sure it is between 10 and 15 psi.

8. Adjust the pressure regulator valve if necessary.

Additional Tips for Opening a Pool

- Before you open the pool, make sure the pool cover is clean and free of debris.

- Inspect the pool liner for any tears or holes.

- Clean the pool deck and surrounding area.

- Test the pool water and adjust the chemical levels as needed.

- Shock the pool with chlorine to kill any remaining bacteria or microorganisms.

- Open the pool to swimmers and enjoy!