How do you re marbelite a pool?

Step 1: Preparation

1. Empty the pool. This is the most important step, as you cannot properly apply the remarbelite if the pool is full of water.

2. Clean the pool. Use a pool brush or pressure washer to remove any dirt, algae, or other debris from the pool surface.

3. Repair any damage to the pool surface. If there are any cracks or holes in the pool surface, you will need to repair them before you can remarbelite.

4. Etch the pool surface. This will roughen up the surface of the pool, making it easier for the remarbelite to bond.

5. Apply a primer. This will help the remarbelite to adhere to the pool surface.

Step 2: Application

1. Mix the remarbelite. Follow the manufacturer's instructions for mixing the remarbelite.

2. Apply the remarbelite. Use a trowel or pool brush to apply the remarbelite to the pool surface. Make sure to apply it in a thin coat.

3. Let the remarbelite dry. The remarbelite will need to dry for at least 24 hours before you can fill the pool with water.

Step 3: Finishing

1. Inspect the remarbelite. Once the remarbelite is dry, inspect it for any defects. If you find any defects, you can repair them using a pool repair kit.

2. Fill the pool with water. Once you are satisfied with the remarbelite, you can fill the pool with water.

Tips for Remarbeliting a Pool

* Make sure to follow the manufacturer's instructions carefully when mixing and applying the remarbelite.

* Apply the remarbelite in a thin coat. If you apply it too thickly, it will not adhere properly to the pool surface.

* Let the remarbelite dry completely before you fill the pool with water.

* If you have any questions about how to remarbelite a pool, consult with a pool professional.

By following these steps, you can successfully remarbelite your pool and enjoy a beautiful, new-looking pool for years to come.