When washing machine in on the spin cycle it leaks water?

There are several possible reasons why a washing machine would leak water during the spin cycle:

Damaged door gasket: The door gasket is a rubber seal that creates a watertight barrier between the washing machine door and the tub. If the gasket is damaged or worn out, water can leak out during the high-speed spin cycle.

Clogged drain pump: The drain pump removes water from the washing machine after the wash cycle is complete. If the drain pump is clogged, water can back up and leak out during the spin cycle.

Faulty water inlet valve: The water inlet valve controls the flow of water into the washing machine. If the valve is faulty, it may not close properly and allow water to leak out during the spin cycle.

Damaged drain hose: The drain hose carries water from the washing machine to the drain. If the hose is damaged or kinked, water can leak out during the spin cycle.

Overloading the washing machine: Overloading the washing machine can put extra stress on the machine and cause it to leak water.

To resolve the problem, you should:

Inspect the door gasket for damage. If the gasket is damaged, it will need to be replaced.

Check the drain pump for clogs. If the pump is clogged, clean it out using white vinegar.

Inspect the water inlet valve. If the valve is faulty, it will need to be replaced.

Check the drain hose for damage or kinks. If the hose is damaged, it will need to be replaced.

Reduce the load size: Try washing smaller loads to reduce the stress on the washing machine.

Reset the washing machine: If you have tried the above steps and are still experiencing a water leak, try resetting the washing machine by unplugging it for a few minutes and then plugging it back in.