We get our manual vacumn to work on inground swimming pool?

1. Gather the necessary equipment. You will need:

- Pool vacuum cleaner head

- Vacuum hose

- Vacuum pole

- Vacuum pump

-Pool brush

- Chemicals

2. Prepare the swimming pool.

- Make sure the water level in the pool is high enough to cover the vacuum head.

- Add the recommended amount of pool chemicals to the water, as per the manufacturer's instructions.

-Circulate your water for atleast an hour before vacuuming.

3. Assemble the vacuum cleaner.

- Attach the vacuum head to the end of the vacuum pole.

- Attach the vacuum hose to the vacuum pump and connect the pump to a wall outlet.

- Ensure that the vacuum cleaner is properly sealed and watertight to ensure optimal suction.

4. Start vacuuming the pool.

- Start from the shallow end of the pool and move towards the deep end.

- Use the pool brush to dislodge any dirt or debris that is stuck to the pool surface.

- Slowly move the vacuum head along the pool floor, ensuring that it covers the entire surface.

5. Empty the vacuum cleaner bag or canister.

- When the vacuum bag or canister is full, turn off the vacuum pump and disconnect the hose.

- Empty the contents of the bag or canister into a trash can.

- Rinse the bag or canister thoroughly before reattaching it to the vacuum cleaner.

6. Continue vacuuming the pool until it is clean.

- Repeat steps 4 and 5 until the entire pool has been vacuumed and all the visible debris has been removed.

- Pay extra attention to areas where dirt and debris tend to accumulate, such as corners, steps, and around the pool drain.

7. Rinse the pool.

- After vacuuming, rinse the pool walls and floor thoroughly to remove any remaining debris.

- Use a garden hose or a pressure washer to rinse the pool.

8. Backwash the filter.

- Once the pool is clean, backwash the pool filter to remove any dirt and debris that was trapped during vacuuming.

- Follow the manufacturer's instructions for backwashing your specific pool filter.

9. Adjust chemical levels:

- Test your pool water and adjust chemical levels back to the recommended ranges to ensure proper water balance.

10. Repeat as needed.

- Regularly vacuum your swimming pool to keep it clean and free of dirt and debris.

- The frequency of vacuuming may vary depending on the pool's usage and the amount of debris that accumulates.

Remember, proper maintenance of your swimming pool is essential for ensuring the cleanliness, safety, and longevity of your pool. By following these steps, you can effectively use a manual vacuum cleaner to clean your inground swimming pool and keep it in top condition.