How can you level a pool that has water in it already?

- A spirit level at least 6 feet long

- Screwdriver

- 2x4 board or scrap wood

- Drywall jack or car jack

- Shims

- Safety glasses

Follow these steps:

1. Measure the water level around the pool. This is the reference for checking the pool level.

2. Place the 2x4 board/ scrap wood underneath the center of the pool to be used with a jack.

3. Place the jack below the 2x4 board/scrap wood.

4. Slowly jack up the pool by about 1 inch.

5. Level the pool using a spirit level. Place the spirit level on top of the pool deck or edge to check if it is level. If it is not level, use shims to raise the low spots.

6. Continue to jack up the pool and level until the water level is 1 inch from the top of the pool.

7. Once the pool is level, slowly release the jack and remove the shims.

8. Re-check the water level and make adjustments as needed.