How to turn on pool jets?

Turning on pool jets typically involves operating the pump and adjusting the valve settings. Here's a general guide on how to turn on pool jets:

1. Check the Pool Pump:

- Ensure the pool pump is turned on and running. If the pump is not running, turn it on according to the manufacturer's instructions.

2. Locate the Jets:

- Identify the pool jets. They are typically located on the sides of the pool, either near the waterline or at the bottom of the pool.

3. Adjust the Jet Valves:

- Look for the valve handles or levers near the jets. These valves control the water flow to the jets.

4. Open the Jet Valves:

- Turn the valve handles or levers counterclockwise to open the valves and allow water to flow through the jets.

5. Adjust the Jet Direction:

- Some jets may have adjustable nozzles that allow you to direct the water flow. Adjust them if desired.

6. Check the Water Pressure:

- Observe the water pressure coming out of the jets. Adjust the valve settings if necessary to achieve the desired water pressure.

7. Turn On the Jets:

- Once the valves are open and the water pressure is adjusted, the jets should start operating.

8. Check for Leaks:

- After turning on the jets, inspect the area around the jets for any leaks. If you notice any leaks, tighten the connections or contact a pool professional for assistance.

Remember that the specific steps and valve configurations may vary depending on your pool equipment and design. If you're not comfortable handling the equipment or are unsure about any steps, it's advisable to consult a pool maintenance professional for assistance.