How do you repair plastic bull nose coping on an in-ground vinyl pool piece broken off where the winter cover snaps in?

To repair a broken plastic bull nose coping on an in-ground vinyl pool piece where the winter cover snaps in, follow these steps:

Step 1: Gather Materials:

- Replacement coping piece (similar to the broken one)

- Measuring tape

- Utility knife or coping saw

- PVC cement or adhesive (specifically for vinyl pool coping)

- Sandpaper (80-grit)

- Safety glasses and gloves

Step 2: Prepare the Surface

- Wear safety glasses and gloves.

- Clean the area around the broken coping to remove dirt and debris.

- Use the utility knife or coping saw to cut away any remaining pieces of the broken coping, ensuring a clean and even surface.

Step 3: Measure the Replacement Coping

- Measure the length of the broken coping section and cut the replacement coping to the same size.

- Make sure the cut edges are smooth and free of any sharp edges.

Step 4: Apply Adhesive

- Apply a thin and even layer of PVC cement or adhesive to the back of the replacement coping, ensuring good coverage.

- Follow the manufacturer's instructions for the specific adhesive being used.

Step 5: Attach the Replacement Coping

- Carefully position the replacement coping onto the prepared area, aligning it with the adjacent coping pieces.

- Press firmly to ensure good adhesion.

- Use a rubber mallet or block of wood to gently tap the coping into place, ensuring it's level with the surrounding coping.

Step 6: Secure with Clamps

- Place clamps over the replacement coping to hold it in place while the adhesive sets.

- Make sure the clamps are evenly spaced and provide sufficient pressure.

Step 7: Allow Adhesive to Cure

- Allow the adhesive to cure and dry completely according to the manufacturer's recommended curing time.

- This typically takes several hours to a few days.

- Do not disturb or put any weight on the repaired area during the curing process.

Step 8: Remove Clamps and Clean

- Once the adhesive has fully cured, carefully remove the clamps.

- Use a damp cloth to wipe away any excess adhesive from the coping surface.

Step 9: Sand the Edges

- Use the sandpaper to smooth out any rough edges or uneven surfaces on the replacement coping.

- Sand until the repaired area blends in seamlessly with the surrounding coping.

By following these steps, you can successfully repair the broken plastic bull nose coping on your in-ground vinyl pool and ensure a secure fit for the winter cover.