Fiberglass steps pulling away from pool how do you fix?

1. Gather your materials:

-Epoxy Adhesive.

-Sandpaper.

-Fiberglass Mesh.

-Acetone or similar degreaser.

-Plastic scraper or putty knife.

-Mixing container and stir stick.

-Safety gloves and eye protection.

2. Prepare the steps:

-Clean the fiberglass steps thoroughly with water and soap to clear any dirt, dust or oil.

-Once the steps are dry, lightly sand them to roughen the surface and make it more receptive to the adhesive.

-Use the degreaser to clean the surfaces and wait for it to dry.

3. Apply the adhesive:

-Mix the epoxy adhesive according to the manufacturer's instruction in the mixing container.

-Using the plastic scraper or putty knife, apply the adhesive evenly to the bonding surfaces of the fiberglass steps and the pool wall or deck.

-Ensure the adhesive is applied to both sides of the gap where the steps are pulling away.

4. Position the steps:

-Carefully position the fiberglass steps into place, making sure they are aligned properly.

-Press down firmly to ensure good contact between the steps and the adhesive.

5. Apply fiberglass mesh:

-Cut a piece of fiberglass mesh large enough to cover the area where the steps are pulling away.

-Place the fiberglass mesh over the adhesive and smooth it out to eliminate any wrinkles.

6. Apply more adhesive:

-Apply another layer of adhesive over the fiberglass mesh to fully saturate it and ensure a secure bond.

7. Allow to cure:

-Let the adhesive cure for the time recommended by the manufacturer( usually 24-48 hours).

-During the curing process, avoid putting weight on the steps.

8. Final touches:

-Once the adhesive has fully cured, you can sand the repaired area to smooth out any rough edges.

-You can also apply a sealant or paint to the repaired area to protect it from wear and tear.

This procedure should effectively repair the fiberglass steps and secure them to the pool. Always read and follow the instructions provided by the adhesive manufacturer for optimal results. If you have any doubts or are uncomfortable performing the repair yourself, it's best to consult a professional with experience in fiberglass repair.