What do you if the water pump is leaking?

Look for coolant dripping or pooling near the water pump. The leak may be from the weep hole, which is a small hole in the pump designed to allow coolant to escape when the seal is damaged. If the leak is coming from somewhere else, such as a crack or loose hose, you will need to replace the water pump.

2. Check the coolant level.

A leaking water pump can cause the coolant level to drop, which can lead to overheating. Check the coolant level in the overflow tank and add coolant if necessary.

3. Repair or replace the water pump.

If the leak is coming from the weep hole, you may be able to repair the water pump by replacing the seal. However, if the leak is coming from somewhere else, you will need to replace the entire water pump.

Here are the steps involved in replacing a water pump:

1. Disconnect the negative battery cable.

2. Drain the coolant from the engine.

3. Remove the belts that drive the water pump.

4. Remove the bolts that hold the water pump in place.

5. Remove the old water pump.

6. Clean the mounting surface of the water pump and the gasket surface.

7. Install the new water pump gasket and apply sealant.

8. Install the new water pump and bolts.

9. Tighten the bolts to the specified torque.

10. Reconnect the belts.

11. Refill the coolant.

12. Connect the negative battery cable.

4. Test the water pump for leaks.

Start the engine and let it run for a few minutes. Check for leaks around the water pump. If there are any leaks, tighten the bolts until the leaks stop.