How to Stop Water Pooling on a Flat Roof?

1. Inspect your roof for any damage or debris. Leaves, dirt, and other debris can block the scuppers or drains on your flat roof, causing water to pool. Make sure to clean your roof regularly and remove any debris that may have accumulated.

2. Check the slope of your roof. If your roof is not properly sloped, water will not drain properly and will pool on the surface. The ideal slope for a flat roof is 1/4 inch per foot. If your roof is not sloped properly, you may need to have it repaired or re-sloped.

3. Install scuppers or drains. Scuppers are small openings in the side of a roof that allow water to drain off. Drains are similar to scuppers, but they are typically located in the center of the roof. If your roof does not have scuppers or drains, you may need to have them installed.

4. Use a sealant to seal any cracks or gaps. Cracks or gaps in the roof can allow water to seep in and cause pooling. Make sure to seal any cracks or gaps with a sealant that is specifically designed for flat roofs.

5. Apply a waterproof coating to your roof. A waterproof coating can help to protect your roof from water damage. There are a variety of different waterproof coatings available, so be sure to choose one that is appropriate for your type of roof.

By following these tips, you can help to prevent water from pooling on your flat roof. This will help to protect your roof from damage and extend its lifespan.