How do you repair a washout in an above ground pool?

To properly repair a washout in an above ground pool wall, use a repair kit specifically designed for this type of repair. These kits typically include a vinyl patch and adhesive, as well as a backing plate to reinforce the repair. The steps involved in repairing a pool wall washout would generally look like this:

1. Preparation:

- Drain the pool water down below the level of the washout (if possible) to allow better access.

- Clean and dry the area around the washout thoroughly to ensure a good adhesion for the repair materials.

2. Apply Backing Plate:

- If the kit includes a backing plate, place it behind the washout area. This will provide additional support for the repair.

3. Apply Adhesive:

- Apply a layer of the provided adhesive to the back of the vinyl patch, ensuring that the entire surface is covered.

4. Position the Vinyl Patch:

- Carefully position the vinyl patch over the washout area, making sure it covers the entire damaged section. Smooth out any wrinkles or air bubbles.

5. Press and Seal:

- Press down firmly on the vinyl patch, ensuring that it adheres well to the pool wall. You may need to use a roller or similar tool to ensure good adhesion.

6. Allow to Dry:

- Leave the repair site undisturbed and allow the adhesive to dry completely according to the manufacturer's instructions (usually several hours or overnight).

7. Refill the Pool:

- Once the repair is completely dry, slowly start refilling the pool. Monitor the repair site for any leaks or issues as the pool fills.

Remember, it's essential to follow the specific instructions provided in the repair kit you are using. Each kit may have variations in the materials and techniques involved in the repair. If you are unsure or uncomfortable with the process, consider seeking professional help for a proper washout repair.