How do you replace plywood sidewalls in an inground pool where the vinyl liner has come off and sides have pulled away?

* New plywood sheets

* Circular saw

* Drill

* Wood screws

* Level

* Tape measure

* Pencil

* Utility knife

* Caulking gun

* Caulk

* Silicone sealant

Step-by-Step Guide

Step 1: Prepare the Pool Area:

1. Remove any water left in the pool.

2. Disconnect and remove any pool equipment, such as filters and ladders.

3. Clear the surrounding area of any debris, plants, or other obstacles.

Step 2: Remove the Old Sidewalls:

1. Use a utility knife to cut the old vinyl liner along the seam where it meets the plywood sidewalls.

2. Carefully pry the plywood sheets away from the pool's metal frame.

3. Remove any old nails or screws that may be holding the sidewalls in place.

Step 3: Measure and Cut the New Plywood:

1. Measure the height of the pool wall.

2. Cut the plywood sheets to match the measured height.

3. Ensure the plywood sheets are large enough to cover the entire side of the pool, including the lip that extends above the pool deck.

Step 4: Attach the New Plywood:

1. Use a drill to pre-drill holes through the plywood sheets, about 1 inch from the edges.

2. Attach the plywood sheets to the pool's metal frame using wood screws.

3. Ensure that the screws are driven in securely, but do not overtighten.

4. Use a level to make sure that the plywood sheets are plumb.

Step 5: Install the Liner:

1. Reattach any removed pool equipment.

2. Install the new vinyl liner according to the manufacturer's instructions.

Step 6: Seal the Seams:

1. Apply a bead of caulk along the seams where the plywood sheets meet the metal frame.

2. Use a silicone sealant to seal around any screws or other gaps.

Step 7: Fill the Pool and Clean Up:

1. Fill the pool with water.

2. Clean up any debris or leftover materials.

Step 8: Enjoy:

Your pool is now ready to be used and enjoyed once more!