If you have an easy set above ground pool that holds 5455 gallons how much bleach and borax baking do use to open the pool?

Pool Chlorine Granules: 2.7 to 3.3lbs (33.5 to 41.2 oz)

Baking Soda: 2.7 to 3.3lbs (33.5 to 41.2 oz)

Borax (optional): 1.5 to 2lbs (19 to 25oz)

Steps to open pool using bleach and borax baking soda:

1. Clean the pool thoroughly, including the sides, bottom, and skimmer.

2. Once the pool is clean and filled, check and adjust the pH level to between 7.2 and 7.8.

3. Add the recommended amount of chlorine granules and borax baking soda to the pool water while the water is circulating.

4. Turn on the pool pump and allow the water to circulate for 24 hours to evenly mix the chemicals.

5. Adjust the pH level again to between 7.2 and 7.8, then add the optional baking soda. The water should be slightly cloudy immediately after the chlorine has been added.

6. Over the next few days, monitor the chlorine and pH levels and adjust as necessary. The chlorine level should be between 1 and 3 parts per million (ppm), and the pH level should remain between 7.2 and 7.8.