How do you get air pockets from behind the pool liner for below ground pools?

1. Preparation:

- Turn off the pool's pump and filter system to prevent water movement and air from getting sucked.

2. Identify the Air Pocket:

- Check for bulges or loose areas on the pool liner's surface. These often indicate the presence of air pockets.

3. Use a Pool Brush:

- Gently brush the areas around the air pocket to help release any trapped air.

4. Water Hose Method:

- Take a garden hose with a nozzle at one end. Insert the nozzle into the pool's skimmer opening or a return jet.

- With the nozzle facing towards the air pocket, turn on the hose. The water flow should help displace the trapped air.

5. Vacuuming:

- Insert a vacuum hose with a pool vacuum head into the pool. Position the vacuum head directly over the air pocket and turn on the vacuum.

- Gently move the vacuum head around to suck out any remaining air bubbles.

6. Push and Press:

- Use your hands to gently press and smooth down the pool liner's surface in areas where there was an air pocket.

7. Leave the Pump and Filter Off:

- Leave the pool's pump and filter system off for several hours to allow any remaining air pockets to settle.

8. Recheck:

- After waiting, turn the pump and filter system back on and check the areas where air pockets were previously found. If necessary, repeat the above steps.

9. Maintain Proper Water Level:

- Ensure that the pool water level is adequate, as low water levels can contribute to the formation of air pockets.

Remember to be patient as removing air pockets from behind a pool liner can be a gradual process. If the air pockets are stubborn or seem excessive, consider consulting a professional pool maintenance company for assistance.