Skateboarding Low box

Question
Could you give me steps to build a low box?

Answer
get a couple of 2 by 4's and some plywood sheets, screws and an angle iron,all you have to do is set out the size square that you would like the board to have , saw the ends of the 2 by 4's at a 45 degree angle, screw them together, do this again, now you have two sqares, saw the fest of the 2by 4' at the desired height add one on each side and two extra one's in the middle of each long side, then just close it all off with the plywood and put the angle iron on one side and you're ready to rip!