PAP 4 inches over & down 1/2 inch
Question
Chip,
I am laying out another friends ball in my garage. He has a PAP of 4" inches over and down 1/2". He is a spinner and has been struggling on oil lately and wants a stack drilling. I struck two arks one from the pin and Cg both 3 1/2 inches away ( the balls pin is out 4 inches ). When I was all done the pin is off to the right of fingers like is suppose to be and CG ends up about inch above thumb hole. If i moved the CG over so it is more of a stacked drilling would it hook more for him?? what do you suggest???
Answer
Crap, I forgot to use the vacation feature as I have been on the road.
The look of your layout is correct. It may require the extra hole to the right and below the thumb hole. I might even move the pine and CG lower to get the pin below the finger holes.
Good luck and sorry for the delay.
Chip
Hinge Start Difficulties
pro shop equipment