How do you install a boat starter on and evinrude outboard motor?

Installing a boat starter on an Evinrude outboard motor involves a few steps. Here's a general overview of the process:

1. Prepare and Disconnect the Battery:

Disconnect the battery from your outboard motor to ensure safety during the installation process.

2. Locate the Starter Solenoid:

- Identify the starter solenoid on your Evinrude outboard motor.

- It's usually a small cylindrical or rectangular device with electrical connections.

3. Remove the Old Starter:

- Locate the old starter, which is typically attached to the flywheel housing of your outboard motor.

- Disconnect the electrical connections and remove the mounting bolts to take off the old starter.

4. Install the New Starter:

- Align the new starter with the flywheel housing.

- Reconnect the electrical connections and fasten the starter using the mounting bolts.

5. Mount the Starter Solenoid:

- Position the starter solenoid in its designated location, which may vary depending on the model of your Evinrude outboard motor.

- Secure it using the provided mounting hardware.

6. Reconnect the Battery:

- Reconnect the battery terminals to restore power to the outboard motor.

7. Test the Starter:

- Turn the ignition key to the "Start" position to test if the new starter is functioning correctly. It should engage the flywheel and crank the engine.

Remember, if you encounter any difficulties or feel uncertain about the installation process, it's best to consult the service manual specific to your Evinrude outboard motor or seek assistance from a qualified marine mechanic.