Design of Clubhead

There are some tips for you to pay attention to the design of the club:

a. Simple shape

Clubhead should be simple in shape, all parts should be rigid, and the structure is natural and practical. Although it is difficult to accurately and fully qualified simple shape, but the following characteristics to be considered a violation of this requirement, it is not allowed:

In addition to putting away, to meet the size specifications for the purpose of targeting or for any other purpose:

(I) holes through the clubhead

(Ii) non-decorative or structural purposes transparent material

(Iii) the head of the main body of the appendage, such as spherical, plate, rod or fin.
Head chute bottom of any trench, or may not extend to the face.

 

TaylorMade Burner Rescue TaylorMade R7 CGB Max Rescue Callaway FT i-Brid Irons

b. Size

The distance from Clubhead to toe should be larger than the ball to the back of legs from the surface. Clubhead size is ready to head to the normal batting position in the level of online measurement the toe and heel, and between the face and back of the outermost point of the vertical projection plane and obtained (Figure 7, Size A). If the heel of the most lateral point calibration is not clear, it is seen as normal in the club is ready to hit the underside of the horizontal position above the shaft 0.625 inches (15.88 mm) office (see Figure 7, size B).

c. Face

Except the putt, there are two characteristics of the two face each other relative outside the club and the clubhead should face only one batter.

Also, we are willing to recommend Titleiest  AP2 Irons to you. They are really excellent.