all the knowledge of Golf ball you need to know

Ball is the most important part of the swing. Ball, the ball is in contact with the face time is only thousandths of a second, all clubs are the same (including the putter). Such a short time, there is no way to make any adjustment action, the ball is just a result.

You can not control the ball, it is reactive action. Our goal is to pursue the ball speed to the maximum from the head to pass the ball, which is the most accurate rate: the ratio of ball speed divided by clubhead speed.

One of the largest wooden precision was 1.5. Wedges and irons are precision rate ratio is not too high. Most accurate rate is not high because: 1, straight face, causing side spin;

2, the swing path error, inside out or outside in, there will be unwanted side spin;

3, ball point of error, too deep or too shallow;

4, ball-point error, hit the pole head or toe, did not hit the middle.

Moment the ball hit the state: USGA (U.S. Golf Association) and Andrew R & A did the test, the solid golf to a certain speed towards a wall of steel shot, test wall in contact with the ball and the moment’s happening in the ball a moment, the ball will be crushed.

In fact, the wooden ball with a One, not only the ball will be crushed, squeezed the face may also occur. (Ball 2) One of modern science and technology of wood, the face is made of titanium metal, thin, about 2 mm. Therefore, the two forces. Irons and fairway woods is not the face of this squeeze effect.

This shaft is too hard there is no bending effect, the distance becomes shorter. Caused by bending the shaft is too soft too. Therefore, shaft hardness must fit your swing speed.

Relationship with the ground ball:

Ball moment, the head does not touch the ground. Is to hit the ball and then scoop the turf. (Ground 1) (ground 2) so that, the club is down angle shots. Not swing the ball round the minimum click, not in the process of hitting up. Only One Wood is in the process of hitting up.

Ball the moment the body actions:

Here to correct three errors:

(1) under the bar to quickly switch hips.

Lower body there would be action, but not that fast on the turn to turn fast. It has turned, but it also has forward drive.

Reach the peak on the pole position: right leg is very solid, very tight, try to turn the upper body. On the lower body between the powerful torque. (Torque on the rod) on the pole the ceiling will be very uncomfortable, the basic word within. If you can hold on the pole, no strong sense of tension, indicating wrong. It is this strong sense of tension and torque, and then make the next shot in the opposite direction driving force.

(2) The head should remain intact.

Some professional players of the head will move down or right slightly.

3) must maintain the spine angle.

On the bar during spine angle does remain basically unchanged. The ball, the spine angle has changed, tilt more.

Correct ball position:

Lower body while moving forward in the rotation. Shaft tilt forward, hands forward. But head to keep the ball on the right. To hit the ball down, not up fishing the ball. To reduce the club face angle, club face angle can not increase. In addition to the 1st of wood, all the other clubs are to be reduced when the ball club face angle.

One block of wood because the holder of the ball, and ball position forward. So when the ball is on the rise. But the body’s movements is the same.