The Knowledge of Club Head

(1) simple shape
General shape of the head should be a simple shape. Should be strong in all its parts, and components for the actual head of ping k15 irons, but should work. As a simple shape, can not correctly, and include defined, but is considered to be satisfied with a simple shape conditions, and is not allowed to rule on the case, described as follows:

To meet Sizes or other purpose:

(I) a hole through the head;
(Ii) a decorative purpose or purposes other than the structure, attached to the head on the transparent material;
(Iii) installed in the head round the body processes, plate, bar, fins and other appendages;
However, putting permitted exceptions. Also, the head or leaves the bottom of the trench shall not exceed the face spillover.

(2) The size and size

1, Wood
The ball with a 60 degree angle to the ground when placed, the head size must be stated:
(I) from the Ministry of head to head with the toe must be greater than the length of the face to the back of head length.
(Ii) from the Ministry of head to head with the toe must be 5 inches in length (127mm) or less.
(Iii) to the peak of the staff from the bottom of the length of the head must be 2.8 inches (71.12mm) or less.

These dimensions are the vertical projection plane of the heel and toe, face and back (see Figure VIII Size A) between the respective front-end level of measurement, or the level of the bottom and the peak of the staff projection plane (see Figure VIII Size B), the vertical measurement between the two front-end gain. If you can not clearly identify the back heel, you can place the ball with that from a distance of 0.875 inches between the horizontal plane (22.23mm) above the site (see Figure VIII size C). Volume of the head should be 28.06 cubic inches (460 cubic centimeters), the tolerance range of 0.61 cubic inches (10 cubic centimeters) or less.

2, Iron and Putter

Usually aim to head the ball placed in position, the size of the head from heel to toe length must be greater than the length of the face to the back. The traditional shape of the head, the size of its vertical projection plane of the heel to toe, face to the back of their level of measurement between the two front-end gain. For non-traditional shape of the head, heel to toe face size can be measured.

(3) The scope of attack
The scope of attack of club head must be only one face. However, putting only the performance of two of attack exactly the same, and made into a relative of attack, you can have two of attack.

 

taylormade r7 cgb max irons

John F. Kennedy: The Best Golf President