With that in mind, here's a temporary fix using JB weld:
1. Clean the Weephole: Make sure the weephole is clean and free of any dirt or debris. You can use a small brush to clean it.
2. Dry the Area: Make sure the weephole and surrounding area are completely dry before applying JB Weld.
3. Mix JB Weld: Mix a small amount of JB Weld according to the package instructions.
4. Apply JB Weld: Apply a small amount of JB Weld to the weephole, making sure to cover it completely. Smooth out the JB Weld so that it is level with the surface.
5. Let JB Weld Dry: Allow the JB Weld to dry for at least 24 hours before adding coolant or starting the engine.
Again, keep in mind that this should only be considered as a temporary solution until you can have the water pump repaired or replaced by a professional.
Fishing Articles : LakeMaster Charts & iPilot LINK Compatibility
Have A Career In Basketball With Basketball Camp
Copyright © www.mycheapnfljerseys.com Outdoor sports All Rights Reserved