How do you increase psi on pump and filter?

1. Check the water level in the pool. If the water level is too low, it can cause the pump to lose prime. Make sure the water level is at least halfway up the skimmer.

2. Clean the filter. A clogged filter can restrict water flow and reduce PSI. Clean the filter according to the manufacturer's instructions.

3. Inspect the pump impeller. The impeller is a rotating blade that creates the suction that draws water through the pump. If the impeller is damaged or obstructed, it can reduce PSI. Inspect the impeller for any damage or debris, and clean it if necessary.

4. Check the pump housing for leaks. A leak in the pump housing can allow air to enter the system, which can reduce PSI. Inspect the pump housing for any cracks or leaks, and seal them if necessary.

5. Replace the pump. If the pump is old or damaged, it may be necessary to replace it. A new pump will be able to generate more PSI than an old or worn-out pump.

Here are some additional tips for increasing PSI on pool pump and filter:

* Use a high-quality pool filter. A high-quality filter will trap more dirt and debris, which can help to improve water flow and PSI.

* Backwash the filter regularly. Backwashing the filter will help to remove dirt and debris that can build up over time.

* Use a pool flocculant. A pool flocculant can help to bind together dirt and debris, making it easier for the filter to trap.

* Use a pool clarifier. A pool clarifier can help to remove cloudiness from the water, which can help to improve water flow and PSI.

By following these tips, you can increase PSI on your pool pump and filter and keep your pool water clean and clear.