On a water pump do you have to take the pulley off get three bolts off?

1. Remove the serpentine belt. This is the belt that drives the water pump, as well as other accessories such as the alternator and power steering pump. To remove the serpentine belt, you will need to loosen the tensioner pulley.

2. Remove the water pump pulley. This is the pulley that is attached to the water pump shaft. To remove the water pump pulley, you will need to remove the bolts that hold it in place.

3. Remove the water pump bolts. There are typically three bolts that hold the water pump in place. To remove the water pump bolts, you will need to use a wrench or socket.

4. Remove the water pump. Once the bolts are removed, you can remove the water pump from the engine.

5. Install the new water pump. To install the new water pump, simply reverse the steps that you took to remove the old water pump.

It is important to note that the steps involved in replacing a water pump may vary depending on the make and model of your vehicle. For specific instructions, you should refer to your vehicle's repair manual.