How can you put a scope on cooey 22 model 82 it doesnt have any slits for regular mount is just round?

There are a few different ways to attach a scope to a Cooey 22 Model 82 rifle. One option is to use a side mount. This type of mount attaches to the side of the rifle, and allows you to mount a scope without having to drill or tap any holes in the rifle itself. Another option is to use a barrel-mounted scope mount. This type of mount attaches to the barrel of the rifle, and is typically more secure than a side mount. Finally, you can also use a rail-mounted scope mount. This type of mount attaches to a rail that has been installed on the rifle, and allows you to mount a scope in a variety of positions.

Here are some specific steps on how to install a scope on a Cooey 22 Model 82 rifle using a side mount:

1. Remove the rear sight. The rear sight is held in place by two screws. Use a screwdriver to remove these screws and take off the rear sight.

2. Attach the side mount. The side mount will come with a set of screws. Use these screws to attach the side mount to the side of the rifle. Make sure that the mount is securely tightened.

3. Mount the scope. Place the scope on the side mount and secure it in place with the included screws. Make sure that the scope is securely tightened.

4. Boresight the scope. Once the scope is mounted, you need to boresight it. This means aligning the scope with the barrel of the rifle so that it shoots accurately. You can do this by using a boresighter or by following these steps:

* Place a target at a distance of 25 yards.

* Fire a shot from the rifle without the scope attached.

* Look through the scope and adjust the reticle until it is centered on the bullet hole.

Once the scope is boresighted, you are ready to go shooting!