How do you tie a knot in jug-line?

1. Hold the end of the main line in one hand and the end of the hook line in the other.

2. Cross the hook line over the main line and bring it up through the loop.

3. Grasp the two ends of the line and pull them tight to form a loop.

Step 2: Pass the hook through the loop

1. Pass the hook through the loop from the bottom up.

2. Pull the hook tight to secure it in place.

Step 3: Wrap the line around the shank of the hook

1. Wrap the main line around the shank of the hook 5-7 times.

2. Pull the line tight to secure it in place.

Step 4: Tuck the end of the line under the wraps

1. Tuck the end of the main line under the wraps of line on the shank of the hook.

2. Pull the line tight to secure it in place.

Step 5: Trim the excess line

1. Trim the excess line from the main line and the hook line.

Step 6: Test the knot

1. Hold the hook in one hand and the main line in the other.

2. Pull on the main line to make sure the knot is secure.

Tips for tying a knot in jug-line

* Use a strong, sharp hook.

* Use a strong, abrasion-resistant main line.

* Use a hook line that is about the same length as the main line.

* Make sure the knot is tied tightly before trimming the excess line.

* Test the knot before using it to make sure it is secure.