What can you use to clean and seal flagstone floors?

- A broom or vacuum cleaner with a soft brush attachment

- A mild detergent

- A bucket of water

- A sponge or mop

- A sealant appropriate for flagstone floors

Instructions:

1. Sweep or vacuum the flagstone floor to remove any dirt or debris.

2. Dilute the mild detergent in the bucket of water according to the manufacturer's instructions.

3. Wet the sponge or mop with the cleaning solution and wipe down the flagstone floor. Be sure to rinse the sponge or mop frequently as it becomes dirty.

4. Once the floor is clean, rinse it thoroughly with water.

5. Allow the floor to dry completely before applying sealant.

6. Apply the sealant to the flagstone floor using a roller or brush. Be sure to follow the manufacturer's instructions for application.

7. Allow the sealant to dry completely, which may take 12-24 hours, before walking on the floor or replacing furniture.

Tips:

- To protect the flagstone floor from scratches, place mats or rugs under furniture.

- Avoid using harsh cleaners, as these can damage the flagstone.

- If the floor is badly stained, you may need to use a special stain remover. Be sure to test the stain remover on a small area before using it on the entire floor.

- Flagstone floors should be sealed regularly to protect them from stains and wear and tear.

By following these steps, you can keep your flagstone floor clean and looking its best.