How do you put water in your camelback backpack?

1. Gather the necessary items:

- Hydration bladder (assuming it's part of your CamelBak backpack)

- Clean water source

- Large sink or bucket (optional, for larger bladders)

2. Prepare the bladder:

- Detach the bladder from your backpack if necessary.

- Locate the fill port, which is usually a large opening near the top of the bladder.

- Unscrew or open the fill port cap.

3. Fill the bladder:

- Place the fill port of the bladder directly under the water source.

- Allow water to flow into the bladder until it's full or reaches the desired level (some bladders have a maximum fill line indicated).

If using a sink or bucket:

- Place the bladder inside the sink or bucket, ensuring the fill port is above the water level.

- Gently squeeze the top of the bladder to create a vacuum and assist with filling.

Note:

- Check if there's a recommended maximum temperature for the water you'll be using, as some bladders may have temperature limitations.

4. Secure the fill port:

- Once the bladder is filled, securely close and screw on the fill port cap to prevent leaks.

- Some bladders have slide or twist locks to ensure a tight seal.

5. Reattach the bladder (if necessary):

- If you detached the bladder from your backpack earlier, reattach it according to the manufacturer's instructions.

Your CamelBak backpack should now be filled with water and ready to use. Remember to test for any leaks before heading out on your adventure!